We no longer sell kits but these questions relating to building a BitScope remain available here for those people wanting to build one using parts they supply themselves.
I'm missing some parts like the 150uh choke (L1) which is in the schematics but not shown on the photo included in the schematic package.
The photo is correct - replace the choke with a link.
Should I follow the silkscreen component values instead of the included schematics ?
Use the schematic, it is more up to date.
R53 on the silkscreen shows 5K7 resistor which is not a standard value.
The photo shows a 5K6 instead which is what you should use, 5K7 value is a typo.
The schematic and board silkscreen show 5 "OP-71" single channel op-amp's. (U14, U15, U16, U23, and U24) but the op-amp's included in the kit are: two TLC071C's, two AD8047's, and one AD8048. Which ones go where ?
The TLC07x op-amps have limited bandwidth compared to BitScope's rated 100 MHz input bandwidth. Why do you use them ?
Can I socket the op-amps and upgrade them later ?
Yes. Depending on demand, we may offer a 100MHz set of op-amps for U25, U23 and U24 (as used in our manufactured versions) as an upgrade. These SMT modules have AD 8065/8066 devices on them with decoupling and 24R feedback resistors (mounted on the underside). By putting the feedback on the SMT module, they are safe to socket. The -ve input pin of the module is not connected to the op-amp. These modules are the ones you see on the photo.
Can I socket the other ICs?
Yes - but use high quality sockets - machine pin if possible. Remember that sockets do increase the lead length and contribute to noise, but probably not a great deal. Most critical are the high speed op-amps - they can oscillate. When we designed the SMT modules, we put the critical feedback resistors on the pcb and disconnect the -ve input from the module pin. TLC071/2 op-amps will be stable in sockets as is.
I found a discrepancy between the schematic and the silkscreen on the PCB. For R63, the schematic says that this has a value of 4K7 and the silkscreen on the board says 10K. In the hi-res picture, it looks more like 10K but I just want to confirm the correct value for this resistor.
Not critical - but use 10K.
What setting should I use for the CLK jumper - 40MHz or 20MHz?
20MHz. At present all BS300 scopes use the 16F871 which runs at 20MHz. Later we may move to an 18F which can run at 40MHz. This will involve changing that jumper.
What do I need to know about soldering a 4 Layer PCB?
Last modified: Tue Jun 8 14:33:40 EST 2010
Copyright © 2019 BitScope Designs