The three registers R0, R1 and R2 are the core virtual machine registers.

They are used to facilitate data entry, register addressing and programming, and related general purpose functions such as data display and address arithmetic.

The techniques described here are used to program all the registers required to make use of BitScope's programmable features.

Data Entry

The following data entry commands "assemble" data in R0, the Data Register:

[	0x5B	ClearR0
0..9	0x30..0x39	Increment R0 by the digit specified and nibble swap.
a..f	0x61..0x66	Increment R0 by the hex digit specified and nibble swap.
]	0x5D	Swap nibbles in R0.

For example, the script to enter the hex value A6 to R0 is [a6].

Address Register Programming

The following register operation commands move data between R0 and registers pointed to by the Address Registers R1 and R2. Two commands are available to initialize the Address Registers:

@	0x40	Copy R0 to Address Register R1.
#	0x23	Copy R0 to Source Address Register R2.

For example, the script to write the hex value B2 to the R1 Address Register is [b2]@ and the script to program the hex value 34 to the R2 Source Address Register is [34]#.

General Register Programming

All other registers are programmed using the following two commands which move data between R0 and any other register addressed by R1 or R2.

s	0x73	Store. Copy R0 to register (R1).
l	0x6C	Load. Copy register (R2) to R0.

For example, the script to program the hex value 0xA0 to the R4 register is [4]@[a0]s. To move a value from register R3 to R9 it is[3]#[9]@ls.

Printing Registers

The value in any register may be "printed" to the serial port to read its value:

p

0x70

Print register (R1).

For example, the script to print the value in R12 is [c]@p. The register's value is printed to the serial port as four characters <CR><DIGIT><DIGIT><CR>.

Increment and Decrement

Increment and decrement commands are available for the convenience of programming:

n	0x6E	Increment Address Register R1.
+	0x2B	Increment register (R1).
-	0x70	Decrement register (R1).

The n command can be quite convenient to write a value to range of registers. For example, to clear registers R3 and R4 use [3]@[sns