This spectrum analyzer shows baseband spectra.
A baseband real-time spectrum analyzer is included as part of the core DSO engine.
Its output is available in most instruments that deal with analog waveform data.
The baseband analyzer is integrated with the instruments it serves, so there are no additional settings to adjust.
Instead the analyzer adapts automatically to the prevailing timebase, scale, volts/div and screen size to display the optimum resolution magnitude (or phase) spectrum of the waveform.
Fig  shows the spectra of the signals connected to the Sydney BitScope as well as the waveforms themselves.
Unlike most swept spectrum analyzers the BitScope spectrum analyzers are fourier transform based and update live at the same high speed refresh rate as the waveform display.
This means it is possible to observe fast moving dynamic features in the spectrum or catch transient spectral events not otherwise visible with a swept spectrum analyzer.
It also means it is possible to zoom and scroll through one-shot waveform captures to view and analyzer the spectrum dynamically at different points in the buffer.
Located at the bottom of the spectrum display is a set of spectrum measurement parameters:
The normal vertical (i.e. magnitude) resolution of the spectrum analyzer is 10 dB per grid line and precise dB levels can be measured using the spectrum level cursors.
The spectrum magnitude display is unreferenced; all measurements are relative to the prevailing V/Div value on each channel. If you wish to shift the spectrum up to see low level signals simply increase the vertical scale of the associated channel.
However, if you wish to make measurements relative to a standard Decibel scale you can reference the display to show dBu, dBV or dBm values as follows:
Frequency Resolution and Sensitivity | EMC Example
Specifically, choose the SHARP display mode to maximize the frequency resolution for a given display size and maximize the display size. For example the screenshot below was taken from a widened display with a frequency resolution of 2000 bins over 1MHz bandwidth (i.e. 500Hz/bin).
Click the screenshot to see an animated recording of this spectrum (Warning: it's a big file, 12MB).
This recording was created by connecting the flying ground lead of a standard oscilloscope probe to the probe tip, increasing the gain of the BitScope channel and then moving the "loop antenna" thus created near a standard desktop PC.
The signals that can be seen are EMI produced by this equipment. This example demonstrates just how easy it is to use BitScope to check for EMI (e.g. for preliminary EMC testing purposes) even using a simple low gain "antenna" as this.
The bandwidth is reported via the BW parameter and the graticule has 10 vertical divisions, allowing quick frequency measurement to be made in much the same way as time measurements may be made with waveform displays. More precise measurements of spectral features can be made using frequency cursors.
Copyright © 2017 BitScope Designs